Product Introduction

The eVapor electronic cigarette (eCig) is an alternative to smoking driven by a micro-electronic technology.

It allows smokers to enjoy the tangible and emotional feeling of smoking without the fire, tobacco, tar, carbon monoxide, ash, stub or smell found in traditional tobacco cigarettes. You’ll get the nicotine crave and the “smoke-like” vapor creates the illusion of cigarette smoke.

Contents of the eVapor Kit:

(A) 1 rechargeable 650mAh eGo battery

(B) 1 refillable clear double coil Cartomizer

(C) 1 USB charger cable

(D) 1 AC outlet adapter (US)

(E) 1 zip-up holster case

eVapor 650mAh battery

Capacity of battery: 650mAh

Constant voltage output: 3.3V        

Switch button protection and better battery protection than the previous eGo series.

eVapor Carrying Case

For convenient carrying of product while you are out. You can carry 2pcs cigarettes, 1pcs USB charger, 2pcs cartridges, and 1 bottle

10ml liquid. Or carry products according to your need.

How to refill your Clearomizer:

1. slowly unscrew the mouth piece off while holding the Clearomizer firmly.

2. At a slight angle slowly pour a desired amount of the eLiquid of your choice. DO NOT OVERFILL.

3. Screw the mouthpiece back on.

Assembling the battery and Clearomizer:

Please refer to picture. Screw the battery and Clearomizer on the thread together to assemble.

Unlock the battery:

For safety reasons the eVapor battery is locked when shipped to customers.

You need to press the button 5 times within 1.5 seconds to unlock.

The led on the button will flash 3 times indicating the battery mode has been unlocked. To lock the battery back press the button another 5 times.

The LED will flash again and then the battery will be locked again.

Use:

Place your lips around the mouthpiece while pressing the button on the battery and inhale. Do not release the button until you stop inhaling.

Clearomizer features and maintenance:

The Clearomizer uses heat to vaporize the liquid. The normal working temperature is 200°c . The liquid in the tank reaches the heating device with assistance from the inhale pressure.

The heat generated by energizing the heating coil and turns that liquid to vapor. If there is more liquid  flowing into the atomizer than can be heated to vapor, it will lead to slight leakage, if there is not enough liquid in the atomizer, then it will have a

slight burn taste.

These are normal conditions, because people have different smoking habits. Your Clearomizer is refillable and reusable, therefore, in order to keep it in a good condition and extend its life span you should clean it every 3-5 refills.

Maintain as Follows:

1. Screw the Clearomizer off the battery and gently unscrew the mouth piece.

2. If access liquid is still present inside the Clearomizer carefully empty it.

3. Carefully unscrew the atomization unit (the metal part) off the Clearomizer tank and set aside.

4. Carefully clean the inside of the tank with a Q-tip or a tissue until dry. (May use sterile alcohol if needed)

5. Carefully wipe access eLiquid of the atomization unit with a Q-tip or tissue and blow through the unit while holding a pice of tissue on the other side to catch the access eLiquid.

In order to remove all of the access eLiquid and usage debris from the atomization unit you may soak it in sterile alcohol.

Please note! If soaked in alcohol it is VERY IMPORTANT to let the unit dry completely before assembling and using again.

Basic performance of lithium battery:

To extend the battery life, please do not subject to hot or humid Environments. Do not throw or squeeze the battery and avoid contact with sharp objects.

Special features of eVapor battery:

The eVapor 650mAh manual battery has a constant output of 3.3V and has safety protection. It has strengthened short circuit protection and over discharge protection.

The eVapor battery is also equipped with a device to prevent overcharging. When the battery is fully charged, charging will stop

automatically. It usually takes 3-4 hours to fully charge.

When an output short circuit happens, the protection device will disconnect the power supply automatically and the battery will be locked. The battery will be unlocked and continue to work when charged again.

Charging the eVapor 650mAh battery:

If the LED button on your battery is flashing when pressing it, it means you need to charge your eVapor battery.

To charge the battery, screw the threaded side of the battery to the USB charger and then connect the USB port to the wall adapter, computer or car adapter*.

The LED on the USB charger will turn red, indicating the battery is charging. When the LED light on the charger turns green, it means the charge is finished.

Lifetime Warranties (Batteries and Chargers):

If your battery or charger fails to properly hold a charge or otherwise malfunctions, call our customer service department at 800.653.8594 and explain the problem.

Our customer service representative will issue you a Return Merchandise Authorization (RMA) number with instructions on how

and where to return the product.

Once returned, we will send you a replacement. When returning the product please use a padded envelope.

Enclose a note with your name, address, phone, e-mail address, RMA number and the reason you are returning it.

Put the RMA number on the outside of the envelope as well.